PCSAT3 Comms Proposal
ISS Exterior Telemetry/Comm System
US Naval Academy Satellite Lab
Bob Bruninga, WB4APR
, POC for comms

External ISS Telemetry/Comms System: There is one or more opportunities for flying an external telemetry/comm system on ISS to support both telemetry, command and control of experimental payloads and to provide an experimental transponder for educational communications experiments. Such an external communications system has flown before on ISS as PCSAT2 . For continuity in nomenclature, this comms proposal is called PCSAT3. It can serve the telemetry and communications needs of such experiments as SCIENCE and LAD-C. Follow the links for more details of the integration of the "pcsat3" telemetry/comm system into those expreiments.

Host Systems: LAD-C is an experiment for detecting the collisions of space particles impacting the ISS. It consists of an aerogel collection array for capturing particles, an accoustic experiment (called Pindrop) to pick up the vibrations of each impact and this proposed communications downlink experiment called PCSAT-3. The SCIENCE experiment is an exterior communications experiment proposal on ISS for educational experience of students, educators and experimenters around the world. This page only addresses the specific details of the PCSAT3 communications portion of these experients.

Since LAD-C is a space environment experiment, the downlinked data will be of interest to students, schools, and the Amateur Satellite community around the world. The public and educational nature of the LAD-C and SCIENCE experiments, plus the communications capablities make PCSAT3 a viable project within the special rules of the international Amateur Satelllite Service. PCSAT3 would support educational and student outreach objectives of both AMSAT, ARRL NASA and DOD as well as provide telemetry on the debris impacts. Students and schools may enjoy monitoring the data directly from their school satellite stations and hearing these impacts.

PCSAT3 Hardware: The image above represents the basic PCSAT3 digital transponder built entirely from COTS products modified for space and with our added control board. This photo is of the ANDE side A transponder. Typically we fly two of these for dual redundancy and reliability and to support additional comunicaitons experiments. This module is about one foot square. The image below is representative of what the system looked like on PCSAT2 which was attached to the backside of the MISSE5 experiment in the same manner. In PCSAT2, the 4 large batteries were 20-times overkill but needed on that mission for heaters for the science experiment.

The antenna requriements for the PCSAT3 type comms payload are very modest and consist of two or four "tape-measure" type antennas as shown below on PCSAT2. Their flexibility makes them immune to damage and also safe for any nearby astronauts.

The PCSAT3comm system would operate in the ITU Amateur Satellite Service in cooperation with ARISS and provide a multi-user communications transponder so that it complies with the ITU rules as shown in an example below. See the Paper on PCSAT's operation in the Amateur Satellite Service or the Full ITU rules as published by the IARU .

SPONSORING ORGANIZATION: The Telemetry/Command/Communications project for PCSAT3 would be conducted under the USNA Small Satellite program. Since PCSAT3 would fly on the ISS, its operations would be fully coordinated with the ARISS (Amateur Radio on the ISS)international team. The block diagram below describes the comms payload:

LAD-C COMMS PAYLOAD DESCRIPTION: The LAD-C comms payload would use the same dual redundant AX.25 command and control system as used on PCSAT2 offering 8 on/off commands, 20 telemetry channels and a bi-directional 9600 baud serial port for the debris detection data collection system. Similar to PCSAT2, the 9600 baud downlink can provide over 3 Megabytes of data per day to the existing volunteer system of internet linked automated ground stations that have served PCSAT1 and PCSAT2 over the last severl years. It also supports the Digital Comms Relay support of the PCSAT/APRS mission.

DOWNLINKS: The PCSAT3 downlink must not interfere with ARISS activity on ISS and so it must operate on UHF when the crew is using the ARISS system for school communicaitons. The rest of the time, PCSAT3 can operate on VHF where there is a 9 dB link advantage. The diagram above shows how the two downlink systems have VHF and UHF transmitters with the default being UHF. Under crew control, these two transmitters can be switched to VHF as needed. Since LAD-C is powered from the ISS external camera port, its transmitters are under the direct control of NASA or the crew for astronaut safety or to avoid any interference with existing ARISS communications.

UPLINKS: Uplinks would be on 10 meters in the 29 MHz satellite band. There are no other emitters on ISS in this band that would cause any interference.

CREW AND EVA SAFETY CONSIDERATIONS:

To provide for EVA Safety, PCSAT2 had to be on/OFF commandable for every EVA and Russian docking evloution. This was a coordination burden for NASA, the Space Test program and USNA operations personnel. For the LAD-C payload, however, which attaches to an external camera mount, we would use the crew-controlled camera power switches to allow the crew direct and immediate internal control over the trnamsitters on LAD-C. The diagram below shows how we intended to use these 4 on/off switches to give the crew functional control over the payload.

(See old 4-inhibit idea)

HARDWARE AND DESIGN DETAILS:

These detail designs all come from the PCSAT2 system, but are presented here as representative of the kinds of circuits proposed for LAD-C.

  • Antenna details:... 19" and 7" whip antennas will be required.
  • Assembly Plans:... Receivers,
  • Command Ckts:.. List, Schematic, TXA/C ckts, TXB/RX/Heater ckts, TNC Resets, and XCD Hold Off.
  • Communications:. Block Diagram .
  • Failsafe timers:.... 96 hour timers.
  • Operations:.........PCSAT3 Operations web page will be initiated for organizing ground stations and volunteers.
  • Ground Equipt:... GSE connector, User Equipment, GSE Test Setup.
  • Mechanical Items: Connector Location sketch.
  • Operations Plan:... Telemetry Collection Plan,
  • Power System:.... Distribution Ckt, Comms Power Budget, and the Actual Power Budget.
  • Prototype Photos:..... Prototype TX and TNC pan.
  • Requirements:...... Initial concept requirements for the AX.25 system.
  • RF Subsystem:.... RF Functional Block Diagram and Frequency compatibility with ARISS.
  • Telemetry Items:... Multiplexer, Telemetry Eqns, and the First TLM data.
  • Wiring Items:......... Cables , Harness , RX internal and TX internal .

    TELEMETRY SCREEN: The screen below shows what the PCSAT3 telemetry screen could look like. Whenever PCSAT3 is on the air, even on the ground in testing, you can monitor the APRS worldwide Internet system and see it.

    PROTOTYPE Circuit Boards:

    Click for high-res

    The TNC COMM system (one of 2) and the dual receivers and dual transmitters.

    The digital communications relay will operate within the ITU regulations for educational/outreach operations in the Amateur Satellite Service, to provide simple Satellite digital communications for amateur satellite operators and educators and possible remote environmental sensors worldwide Examples . This comms mission will provide a follow-on extension to the educational communications mission of PCsat, Boats at sea, cross country travelers, expeditions, or other travelers far from existing APRS terrestrial communications infrastructure. The Transponder and LAD-C data is captured by existing PCsat-to-Internet ground stations and fed into the existing worldwide internet linked APRS system. The LAD-C mission would join ISS, MIR, PCsat and several other on-orbit experiments (ASTARS) that have been conducted over the years leading up to this exciting capability.

    Here are several additional PHOTOS, DRAWINGS and Documents:

  • Terminal Node Controller (photo)
  • TNC mods for telemetry
  • UHF 2 Watt Transmitter (photo) (VHF shown, but UHF is similar)
  • VHF receiver (photo)
  • Evolution/Chronology of this project.

    The AX.25 segment of the PCSAT2 communications mission has been demonstrated a number of times in space via PCsat, MIR School tests, the Shuttle SAREX, and the SPRE mission. . It is also a spin off of a previous launch opportunity that we had in 1998 called NATSweb that almost got launched on SEA-LAUNCH.. The PCSAT2 Communications mission is a project to produce a viable external ISS payload in a very short time frame using off the shelf components where possible. Here are the background topics of design:

    APRS is the Automatic Position Reporting System that the Naval Academy uses for tracking its boats and a variety of other vehicles and networks using the APRS Automatic Position Reporting System . The PEC Communications transponder would be operated under the rules of the Amateur Satellite Service and the rules of the FCC.

    You are visitor: .


    USNA Satellite Ground Station

    PCsat

    Midshipmen Amateur Radio Club